1st Shift Press Operator

1st Shift Press Setup/Operator

PAY:

Essential Functions

• Prepare press
• Set die in press
• Set coil and feed length
• Run parts for inspection approval
• Monitor press
• Document statistical process control

Prepare Press

• Unbolt/ unclamp die
• Remove scrap and lubricant from press
• Empty and clean buckets and barrels
• Clean bolster
• Repeat with each run
• Adjust arm jerkers

• Push die on to the bolster
• Adjust die to the center
• Push button to position ram
• Bolt/ clamp upper half of die to ram (use socket wrench)
• Check die alignment
• Bolt/ clamp lower half of die to the bolster

• Load coil (hoist or chain fall) on to reel or in cradle
• Remove the banding on the coil by cutting with metal cutters
• Feed strip into the press feed
• Activate switch, advance coil through the die
• Install lube line, air blow offs, and chutes

• Run press
• Check parts of gauging/ measuring
• Obtain inspection approval

• Check for proper feed
• Lubricate as necessary
• Check chutes, bolts, and parts being blown out

• Pick up part
• Measure part
• Return part to bin
• Record measurements

COM018
Nesco Resource provides equal employment opportunities to all employees and applicants for employment and prohibits discrimination and harassment of any type without regard to race, color, religion, age, sex, national origin, disability status, genetics, protected veteran status, sexual orientation, gender identity or expression, or any other characteristic protected by federal, state, or local laws.