Detroit Engineered Products
Electronics & Lethality Hardware Engineer Job at Detroit Engineered Products in
Detroit Engineered Products, Sterling Heights, MI, United States, 48314
Position Requirements:
Knowledge in many, but not all, of the following areas desired
- Bachelors degree in Electrical Engineering, Computer Engineering (BSCE), Mechatronics, Robotics or related degree program
- 2+ years of relevant experience on up
- Ability to use Engineering Development and Test Tools.
- Ability to develop technical solutions to complex problems
- Ability to interact with senior external personnel on tech matters
- Aware of and directs activities towards completion of major program goals
- Ability to travel to supplier and government sites as needed
Knowledge in many, but not all, of the following areas desired
- IPC and MIL standards
- Digital and Analog circuit design
- Gyroscopes, Encoders, and Cameras
- Development of component/subsystem requirements
- Model-based Motion Control
- PWM and PID
- Test Equipment (Power Supplies, Oscilloscopes, Function Generators, DACs)
- Power, thermal analysis, timing, biasing, voltage and current control, LED control, data packet deciphering, etc.
- Schematic development, component selection, circuit simulation, and PCB layout
- Engineering design, development, and analysis software
- Servo Control experience
- MATLAB Simulink Control experience , MATHCAD, Mentor Graphics Schematic Capture, CAMView or CAM350
- Microprocessor based products including processors, chipsets, memory and bus interfaces, networking standards (PCI-xpress, DDR2, DDR3, USB, SATA, DVI, etc...)
- Microcontrollers including IDEs, configuration, coding, programming and NXP family of microcontrollers
- Industry interface standards and form factors (VITA42/46, COM Express, ETX, etc.)
- Serial Interconnects, USB, CAN, RS422/485, etc.)
- Graphics/video interfaces (SDI, DVI, HDMI, RS-170, etc.)
- EMI/EMC design practices and standards.
- C, C#, VisualStudio Suite